TONE GENERATOR
Shure Incorporated
| The Shure A15TG Tone Generator is a battery-powered 700 Hz signal source that can be used to troubleshoot low-impedance, balanced-line microphone inputs. The A15TG includes a recessed On-Off switch and a three-pin XLR audio connector. A removable end cap allows easy battery installation and removal. The A15TG can also tolerate the presence of phantom power, or a short circuit in the line it is driving. Built-in short circuit protection allows normal operation to resume after a short is removed. The A15TG can operate continuously for approximately 1000 hours on one 1.5V alkaline battery. To conserve battery power, make sure the On-Off switch is in the Off position when the A15TG is not in use. This item is currently low on stock. Please let us know if you would like to order this item. |   |
 » Switchable Attenuator - (A15AS) Use the A15AS balanced-line attenuator to prevent low-impedance microphones (rated at 150 or 600 ohms) and high-output condenser microphones from overloading » more » High Pass Filter - (A15HP) The Shure A15HP filter rolls off low audio frequencies to reduce 60 Hz electrical hum, low-frequency wind noise, air conditioner noise, » more » Line Matching Transformer - (A85F) The Shure A85F is a low- to high-impedance microphone-matching transformer that provides 24 dB of signal increase gain. It has balanced » more » Line Matching Transformer (xlrm - Ts) - (A95U) This reversible transformer matches low- or high-impedance microphones to high- or low-impedance inputs. The transformer permits use of very long microphone » more » Line Matching Transformer (xlrf - Ts) - (A95UF) The Shure A95UF is a reversible transformer that matches low-impedance microphones to high-impedance inputs or high-impedance microphones to low-impedance inputs. The » more » Camcorder Interface 0.6m (3.5mm - Xlrf) - (A96F) The Shure A96F transformer connects microphones with an XLR-type connector to the 3.5 mm inputs found on camcorders and other recording » more | |
